3''/4''/6''/8'' Inch Hydraulic Dies Ce Certification Fitting Ferrule Crimping Machine

Λεπτομέριες

Part no.: YHHC-48B
System: computer controlled system
Standard dies: 16 sets of dies from 1/4’’ to 3’’
Voltage: 380V/50HZ; if other voltage required, please advise us.
Stock available: we have kept many types in stock, then we can ensure the fast delivery.

Πίνακας τεχνικών δεδομένων

Type	YHHC-48B (computer system controlled)
Crimping range	Φ6—φ76 4SP
Motor	Y-4/4kw
Voltage	380V*50HZ
Capacity of oil pump	19L/min
Συστηματική πίεση	30MPa
Hydraulic oil	Winter ：YB-N32
Hydraulic oil	Summer ：YB-N46
Oil tank volume	480×440×360mm3
L * W * Η	800×650×1350（mm)
Crimping pressure	903T

Η υπηρεσία μας

1.We have many agents all over the worlds, so you can contact our agent to buy our products
2.Technical support any time, Our engineer cellphone:
+86-15158322675
3.Warranty time 3years, the warranty card with machine together to you.
4.Supply Video to learn how to use machines.
5. Door to door service, we are in charge of sending the machine to your office, after payment.fitting ferrule crimping machine
6.we can design machines as your draw and requirements. OEM

Συχνές ερωτήσεις

Trouble phenomena	Trouble reason	Eliminating method
Machine has not action	Oil tank has not been filled with oil	Fill oil as per requirement
	Motor rotation direction is not correct	Regulate two phase lines
	Electric trouble	Overhaul electric circuits
Scale is damaged	The scale is fastened on the oil cylinder end face by the screw	Regulate the scale as per the instruction to make scale to telescope freely
	Conductor at scale location is connected with scale	Anew connect the scale conductor to make it to be insulated from scale base
	Electric trouble	Overhaul electric circuits and electric elements
	Scale conductor cutting	Anew connect scale
	System pressure is excessively low	Adjust buckling pressure-regulating valve
No buckling	The valve core of solenoid reversal valve is seizured by foreign matters	Dismount solenoid reversal valve, use gasoline to clean the valve core.
No buckling	Electric trouble	Overhaul electric circuits
Mould is not opened	Opening mould pressure is excessively low	Adjust opening mould pressure regulating valve
	Electric trouble	Overhaul electric circuits
	Lubrication is poor	Smear grease on the working inclined face of mould base
Oil leakage	Joint is not tightened closely	Tighten the oil pipe joint
Oil leakage	Sealing washer is damaged.	Replace sealing washer